Roxell Vitoo In Line, Use And Assembly Manual

Page: 62 / 106

ROXELL - 008- 2004 VITOO IN LINE -- INSTALLATION INSTRUCTIONS
III--8
3x240V
3x200V
N
N
3x220V
(IEC38--N)
(IEC38--3x230V)
ELECTRICITY .... WATCH OUT !
LEAVE CONNECTIONS TO THE SYSTEM TO A QUALIFIED ELECTRICIAN !
-- Wire the system with the utmost care and attention.
-- Always provide a solid earthing.
-- Check all connections before you switch on.
-- Always follow the wiring diagrams included in the control panels.
-- Compare setting of the thermic protection with the data on the motor label. Thermic protections are set at minimum by
the manufacturer.
-- If you do not use a Roxell control panel, make sure to provide the necessary thermic protections.
-- Compare motor label plate and motor connection with local voltage :
ELECTRICAL WIRING DIAGRAM
SEALED PARTS IN CONTROL PANELS MUST UNDER NO CONDITION WHATSOEVER BE UN-
SEALED !
ONLY THE CONNECTION DIAGRAM IS SHOWN IN THE ASSEMBLY GUIDE. WIRING DIAGRAMS ARE
ALWAYS SUPPLIED WITH THE CONTROL PANELS.
FIGURE 5.
FA II
FA I
1
2
2
9
3
3
4
5
6
(N / N
(N IEC 38
3x200V / 3x220V
3x230V IEC 38
/ 3x240V).
Control pan
7
Cut--off switch
8
7
3
8
8
1. Supply cable
2. Cable Flex--Auger power units (3x2,5+2,5).
3. Cable drive units (3x2,5+2,5).
4. Cable max. sensor weigher (4x1,5) + safety switch FA II (2x1,5).
5. Cable impulse switch weigher (2x0,75+0,75).
6. Cable safety switch Flex--Auger I (2x1,5)
7. Cable sensor control pan (2x1,5).
8. Cable mix. switch hopper (2x1,5)+ safety switch
9. Cable max.sensor Flex--Auger (4x1,5).
10. Cable min. sensor weigher (4x1,5).
10
Central control panel
Weigher
Drive unit
Bin