Roxell Vitoo In Line, Use And Assembly Manual

Page: 12 / 106

ROXELL - 008 - 3911 VITOO IN LINE -- INSTRUCTIONS FOR THE USER
I--6
The feeding cycle continues until the desired amount of feed is
available in the house. At that moment, the motors of the lines
and the supply Flex--Auger stop.
The meal ends when all feed in the pans has been consumed.
The tubes of the lines and the Flex--Auger are full of feed: this
is a ”reserve” for the next meal (the day after). When the sys-
tem starts the next day, all pans are filled immediately.
All birds can eat at the same time. This guarantees a very good
uniformity. Because the amount of feed remaining in the tubes
is the same after each feeding, the birds get the same amount of
feed at each meal.
Make sure that the control pan is the last but two pans on the
feeder line.
When the system operates correctly and when there are
enough birds eating from the control pan, you do not have
to adjust anything. The system adjusts itself.
Depending on the composition of the feed, it may happen
that no feed falls into the last pans.
If this is the case, you can easily remove the control pan (fig.
100.) and replace it with another pan. You then install the
control pan two or three places further (to the front) on the
feeder line.
Take care that just enough feed falls into the last pan. Too
much feed in the last pan means feed waste.