Roxell Vitoo In Line, Use And Assembly Manual

Page: 55 / 106

ROXELL - 008- 3911 VITOO IN LINE -- INSTALLATION INSTRUCTIONS
III--3
1. Be CAREFUL when handling the ROLLS OF AUGER.
--
When you release the BINDING WIRE, it is possible that the auger UNROLLS. This
can cause injuries.
--
ALWAYS use SAFETY GLOVES when you slide the auger into the tube.
--
ALWAYS see that the auger CANNOT SPRING BACK (by using clamps) when you
put it under tension .
2. Check all TUBE CONNECTIONS and all TUBE CLAMPS on control units, feed intake
boots and bearings for PROPER CLAMPING. Tighten all tube clamps with a TORQUE
of min. : 10Nm.
3. TEST the SUSPENSION SYSTEM for safe operation :
--
Firmly fasten the WINCH and the SUSPENSION POINTS. Firmly tighten ALL
CABLE CLAMPS.
--
WINCH UP THE FEEDER LINES THREE TIMES and lower them again (full
course). NEVER STAND UNDERNEATH THE SYSTEM when doing this.
--
Winching up and lowering must proceed WITHOUT ANY HITCH.
4. At the FIRST START UP, make sure that, if the auger HITCHES or BLOCKS, you can
IMMEDIATELY SWITCH OFF the system with the main switch on the control panel.
GENERAL SAFETY RULES
IMPORTANT
LINE SYSTEMS
Carefull read the following instructions be-
fore you
INSTALL
the system
This SYMBOL will be used to draw your attention to matters that are
of GREAT IMPORTANCE for your SAFETY .
It means :
WARNING
- follow the safety instructions :
disconnect the current - re-read the safety rules.
In short :
BE ALERT .
IGNORING these instructions can cause SE-
RIOUS INJURIES or even DEATH.
DANGER