Roxell Vitoo In Line, Use And Assembly Manual

Page: 87 / 106

ROXELL - 008- 3911 VITOO IN LINE -- INSTALLATION INSTRUCTIONS
III--33
TO INDEX THE FEEDER TUBES
Attention : do not change the indexing when resetting the feed intake boot at 0

. or when tightening the clamps (e.g.
the tubes must not turn).
Turn the feed intake boot 180

Let it rest on a support, so that the pans do not touch the floor. This allows you to index the
tubes in the correct way. Winch up the line to level it.
FIGURE 60.
Take care to secure the feed intake boot firmly, so that it
does not
come
loose from the support.
Feed intake boot turned 180

.
FIGURE 61.
1. Always start indexing at the boot.
2. Place the indexing gauge on the expanded end of the tube, as
indicated on fig., with indexing disc upwards
3. Choose the correct chart according to the number of pans
per tube (e.g. 1 pan/tube)
4. Use the indexing chart. You will find a series of cipher and
letter combinations which correspond to the decal on the
indexing gauge. In the chart column which corresponds to
the length (i.e. the number of tubes) of the line, you will
find the indexing positions tube by tube. No. 1 starts at the
100 kg hopper.
5. Turn the tube until the air bubble in the level glass gets ex-
actly between the 2 dashes.
6. Turn the tubes separately/one by one by means of multigrip
pliers, not by means of the indexing gauge. See to it that the
outlet holes are at the right side of the tube. (The V--shaped
opening is pointing downwards !)
7. Tighten the tube clamp firmly on the expanded end. Respect
the indicated distance (= 1cm ). Do not deform the tubes.
8. When turning the next tube, hold the previous one already
indexed, to avoid that it turns along.
FIGURE 62.
Always proceed in the same way to put the indexing gauge on the tube, e.g. : by putting the bolt
always down into the slot of the expanded end.
Power unit
Feed intake boot