Roxell Vitoo In Line, Use And Assembly Manual

Page: 103 / 106

ROXELL - 008- 3911 VITOO IN LINE -- INSTALLATION INSTRUCTIONS
III--49
WIRING DIAGRAM AUTOMATIC OUTLET
Feedback of OPEN/CLOSE signal by digital input or relay.
Both signals OPEN & CLOSE which come from the Automatic Drop can be connected to a 24 VDC relay.
In MFII application can the feedback be directly connected to a IDM.
Declaration signalling LED
24VDC+Close LED Blue
Motor OPEN LED Blue blink
Motor Alarm LED Red
Motor Calibration LED Green
With blocking motor alarm LED Red
Remove DROP.
Remove possible blocked feed.
Switch 24VDC OFF.
Switch 24VDC ON.
Calibration starts automatically.
LED Blue
Technical specifications
Voltage 24 VDC

20%
Motor Current Stand--by 20 mA
Motor Current OPEN/CLOSE 150 mA
Motor Current Alarm
400 mA
Relais output 24VDC
100 mA
Max. Cable Length
200 M
Min. Cable Section 0.5mm
2
max.100 M
Min. Cable Section 0.75mm
2
max. 200 M
Remark
After interruption of voltage in “OPEN position, one don’t look for 15 sec. the input, so the “OPEN position” re-
tains.
THE AUTOMATIC OUTLET STARTS AUTOMATICALLY. NEVER PUT YOUR HANDS IN
THE OUTLET OR IN THE DROP HOLE BEFORE MAKING SURE THAT THE CURRENT
IS SWITCHED OFF.
DANGER
ATTENTION : Contact ROXELL for professional advice when using following feeds:
CCM (Corn Cob Mix).
Feed mixed with CCM.
Soya.
Soya lumps.
Wet feed.
Without explicite authorization, all our warranties will expire and no claims will be accepted.
Also contact Roxell if you want to use strongly grating feeds like hen feed etc...