Roxell Vitoo In Line, Use And Assembly Manual

Page: 88 / 106

ROXELL - 008- 3911 VITOO IN LINE -- INSTALLATION INSTRUCTIONS
III--34
FIGURE 63.
Very important : it is highly recommended to mark each expanded end of the indexed couple of tubes, and to indi-
cate the number of the tube :
-- In order to make it easier to keep the exact number on the scale with the exact tube.
-- In order to check after the indexing whether the tubes have not turned separately. This check is still pos-
sible at any later time.
6 6
FIGURE 64.
After correction, put all feeder pans back into horizontal position (when needed).
SOME PRACTICAL TIPS :
-- Walk along the lines during the first feedings, to see whether no irregularities have occurred in the indexing. (Parts of
the line which get more or less feed.)
-- Due to diversity in the kinds of feed, it is possible that in the front of at the back of the feeder line, too much (or too
little) feed accumulates because of the position of the feed in the tube.
If too little feed in front (too much in the back) : turn the tubes somewhat lower.
FIGURE 65.
FIGURE 66.
Proceed as follows : loosen the tube clamps at the feed intake boot and control unit.
If too much feed in front (too little in the back) : turn the tubes a bit higher.