85
6.3
Status of Scanner
The following information is given under
Status
:
Status of connection between scanner
and PC
Whether an original was placed and if
yes its approximate width
Whether calibration is required
Whether maintenance by the ROWE
Service is required
Under
Protocol
you can see the scanner's intensity
of utilization. There you can see the number of
scans already effected, the overall scan length, as
well as the operating hours of the scanner.
Under
Version
you can see detailed information
on the software version as well as firmware of the
scanner. Usually, only the entry "
Software Release
"
(here 1.3.0) is important.
Figure 6.3: ConfigManager - Status
6.4
Calibration
Under
Calibration
you can calibrate the scanner
again. A new calibration is always recommended if
the scan quality seems to have deteriorated.
Moreover, calibration is to be effected at regular
intervals – depending on the degree of utilization.
In order to perform a calibration you simply have
to follow the instructions given on the screen. In
this respect, also refer to Chapter 2.11).
Figure 6.4: ConfigManager - Calibration
