30
3.1
Connection of Power Unit
The scanner is switched ON by connecting the power unit to a socket. The connector for the
power unit is located on the back of the scanner on the right. (see
Figure 3.1). If the device is switched ON, the operating LED under the green button (2) on the
control panel (see Figure 3.2) lights up.
During the installation process switch the scanner ON only after being prompted to
do so.
The scanner works properly only after
installation of the ROWE Scan 450i software (see
Chapter 2) prior to use.
Plug the connector of the power unit into the
socket to switch the device ON.
Figure 3.1: Position connector power unit
On the control panel of the scanner (see also
Figure 1.2 on Page 15) you see two LEDs. After having
switched ON the device, the operating LED under the
green button (2) lights up.
Should a failure occur (e.g. paper jam), the LED under the
red button (1) lights up.
If the operating LED under the green button (2) is
flashing, the scanner is in
energy saving mode
. In this
mode, the scanner is not recognized by the PC. In order
to put the scanner into operation again, simply press the
green button once.
If you do not use the scanner for a longer
period, pull the mains plug.
Figure 3.2: Control panel
