Ross Carbonite Ultra Series, User Manual

Page: 32 / 202

normally covered by the animation when the
layer is above the key.
6. Click Edit Media Trans .
7. In the Media Over area, select the type of
transition you want to use under the
MediaWipe. This also allows you to set up
the transition parameters for wipes and DVE
transitions.
8. Click Trans Time and use the slider or fader
in the Transition area on the control panel
to set the start and end of the transition
under the MediaWipe.
• (Cut only) Use the
Cut Frame slider to
select the point for the cut, or move the
fader to the point in the animation where
you want the cut to happen and click Cut
at Fader Position .
• Use the Start Trans At slider to select the
point where the transition starts, or move
the fader to the point in the animation
where you want the transition to start
and click Start Trans at Fader Position .
• Use the Trans Rate slider to select the
duration of the dissolve, or move the
fader to the point where you want the
transition to end and click End Trans at
Fader Position .
Tip: If you select a negative start point for the transition,
the transition will start first and then the animation will
play after the start point duration has passed.
9. Click Thumbnail and use the Thumbnail
slider to select a point in the animation that
you want to use as a thumbnail for the
MediaWipe. You can also use the fader to
select the position and click Generate
Thumbnail at Fader Position .
10. Click Save to save the new setting to the
selected media item.
11. Click Exit Edit Media Trans .
32 • Transitions — Ultra User Manual (v6.6)