Page - 112 -
FLF 15000/1800/500
Panther 8x8 CA-7
© 2014
Maintenance
Torque list:
Bolting to glass fibre-tank:
(flange and threaded bushes; approx.
20% of steel value)
M 8
8.8
5 Nm
M 10
8.8
10 Nm
M 12
8.8
17 Nm
M 16
8.8
40 Nm
M 20
8.8
80 Nm
Sub frame:
M 10
10.9
65 Nm
MB-screw steel to steel
M 10
10.9
58 Nm
cast aluminum-bracket to sub frame
M 8
8.8
24 Nm
silent bloc to cast aluminum-bracket
Propeller shaft:
M 8
10.9
36 Nm
steel to steel
M 10
10.9
72 Nm
steel to steel
The bolting (under the screw head and
on the thread) must not be oiled under
any circumstances and invariably
tighten by using a torque wrench !
Chassis-thrust plate:
M 12 x 1.25
10.9
125 Nm
M 14 x 1.5
10.9
195 Nm
Superstructure (according to DIN/
ÖNORM):
flat headed screw
12 Nm
M 8
8.8
21 Nm
M 10
8.8
42 Nm
M 12
8.8
72 Nm
M 14
8.8
114 Nm
M 16
8.8
174 Nm
Service procedures - Chassis
All screws and bolts between the superstructure and chassis
frame must be re-tightened after the first 500 km and then
regularly checked at least every 5000 km or at least every year.
Replace damaged parts of the suspension immediately.
Check if the bolts are tight (please refer to torque list).
The vehicle is operated in extreme temperature, driving and
atmospheric conditions; therefore check the hollow protection and
underseal of the complete vehicle at least once a year and repair
if necessary.
Check for any rust spots or damages and repair them immediately.
At the same time apply corrosion protection for any replaced or
repaired part. An approved corrosion preventing plastic paint for
this purpose, may be obtained from Rosenbauer International
Aktiengesellschaft.
Roller shutters *
On roller shutters, the sliding-guide rail must be lubricated with
Teflon spray Rsb. art.no. 535553 or equal quality, at regular
intervals (every 6 months).
Service procedures - Air dryer
An air dryer is installed in the compressed air supply system, close
to the board compressor. The drying agent filter is to be changed
every year.
ATTENTION !
Please obey current disposal regulations.
