Rosemount 5600 Series, Reference Manual

Page: 67 / 210

Reference Manual
00809-0100-4024, Rev BA
September 2005
3-3
Rosemount 5600 Series
Figure 3-2. Schematic
illustration of the Rosemount
5600 transmitter connection
CABLES
Depending on local requirements, cable glands, or explosion proof conduits
must be used for connection to the non-intrinsically safe junction box (EEx e).
For the connection to the instrinsically safe junction box (EEx i) use cable
glands with integral shield connection for cable diameter 6-12 mm or conduit.
Use shielded instrument cable 0.5 mm
2
(AWG 20) for analog outputs and
serial communication. Use min. 0.5 mm
2
cable for power supply.
POWER SUPPLY
You can use either DC or AC as the built in power supply has a wide input
range. The following specification is valid for the power supply:
• 24-240 V
• DC/AC 0-60 Hz
• 10 W
• 15 VA
There is no voltage selector in the electronics compartment since the
transmitter power supply unit automatically adapts to the available voltage
within specified limits.
NOTE
The minimum voltage required at the transmitter power terminals is 20V.
Check that the voltage loss over the power cables is not large enough to
make the voltage drop below 20V. The maximum voltage is 265V over the
same power terminals.
5600-CONFIG_EXAMPLE2, 3,
4_ED3, TH40HEAD_ED3_2
Primary Out
Non-IS
Secondary
Output
Primary
Output IS
X1
1
2
3
4
1 2 3
4 5 6
7 8 9
X2
6
5
4
3
2
1
7
6.767
Level
m
1 2 3
4 5 6
7 8 9
Junction
Box X1
Junction
Box X2
HART
®
Interface
X2
1
2
3
4
Optional
EEx e Secondary
Output
1 and 2 Not used