Galaxy Raid GHDX4 SAS<>SAS/ SATA 12Bay
Installation / Hardware Reference Manual
5-14
5.6.2 Replacing a Cooling Module
If one of the cooling modules fails, it must be replaced as soon as possible.
To replace the cooling modules, follow the steps below:
WARNING!
The fan replacement process should be completed within five (5)
minutes. If the process takes too long, the accumulated heat can
damage the system.
Step 1.
Snatch the retention latches towards the center, and then
pull the cooling module out of the chassis.
Removing a Cooling Module
Step 2.
Install the replacement module by pushing it into the
module bay.
When fully inserted, the retention latches will hold
the module in place.
Step 3.
A firmware event will prompt shortly afterwards stating that the
cooling module is back online. The LEDs on the replacement
module should not be lit when installed.
