Roland V-Drums TD-20X, Owner'S Manual

Page: 64 / 156

64
Chapter 4. Effect Settings
FLANGER
Produces a metallic resonance that rises and falls somewhat
like a jet airplane taking off or landing.
PHASER
Adds a phase-shifted sound to the original sound, producing
a swirling modulation.
CHORUS
Gives richness and spaciousness to the sound.
ENHANCER
Controls the overtone structure of the high frequencies,
adding sparkle and brightness to the sound.
PITCH SHIFT
Shifts the pitch of the original sound.
OVERDRIVE
Creates a soft distortion similar to that produced by vacuum
tube amplifiers.
DISTORTION
Produces a more intense distortion than Overdrive.
Parameter Value Description
Delay 0–15.0 (ms) Tone of the flanger
LFO Rate 1–128 Frequency of modulation
Depth 0–127 Depth of modulation
Feedback -98–98 (%)
Amount of the flanger sound
that is fed back into the effect
(minus: inverts the phase)
Phase 0–180 Spatial spread of the sound
Parameter Value Description
Freq 100–8000 (Hz)
Basic frequency at which the
sound will be modulated
LFO Rate 1–128 Frequency of modulation
Depth 0–127 Depth of modulation
Resonance 0–127 Amount of feedback
Parameter Value Description
Delay 8.0–30.0 (ms) Tone of the chorus
LFO Rate 1–128 Frequency of modulation
Depth 0–127 Depth of modulation
Phase 0–180 Spatial spread of the sound
Parameter Value Description
Sens 0–127 Sensitivity of the enhancer
LF Level 0–127
Volume level of the low
frequency range of the direct
sound
Parameter Value Description
Mode 1–5
Setting a higher value results
in a slower response, but
steadier pitch.
Delay 0–100.0 (ms)
Time until the pitch-shifted
sound is heard
Coarse -24–12
Amount of pitch shift
(semitone steps)
Fine -100–100
Amount of pitch shift (2-cent
steps)
Feedback -98–98 (%)
Amount of the pitch-shifted
sound that is fed back into the
effect (minus: inverts the
phase)
Parameter Value Description
Drive 0–127 Amount of distortion
HF Level 0–127 Level of high frequency range
LF Bypass OFF, ON
Bypass for the low frequency
range
When this is set to “OFF,”
the low frequency range
also has a distortion sound.
Expanse OFF, ON
Adding the spatial spread of
the sound
Parameter Value Description
Gain 0–127 Amount of distortion
HF Level 0–127 Level of high frequency range
LF Bypass OFF, ON
Bypass for the low frequency
range
When this is set to “OFF,”
the low frequency range
also has a distortion sound.
Expanse OFF, ON
Adding the spatial spread of
the sound
TD-20X_e.book 64 ページ ２００９年６月８日 月曜日 午後３時５０分