Roland TrueVIS VG3-540, User Manual

Page: 38 / 341

After this procedure is completed, if the left and right side positions do not fit the proper positions when se-
curing the media with pinch rollers, you will have to go back to this step to redo this procedure. If you just
hold the media to readjust its position forcibly, the media will be skewed during printing, which will have an
adverse effect on the printing results.
2.
Secure the media holders.
3.
Use the following procedure to load the media.
Doing so will prevent media skewing.
(1)
Pass the leading edge of the media between the pinch rollers (A) and the grit rollers (B).
(2)
Feed the media until you hear a beep, and then additionally feed approximately 20 cm (7.87 in.) of
the media.
You will hear a beep. Approximately 5 seconds later, you will hear two beeps, and then the
suction fan will activate. While this fan is operating, the position of the media will be main-
tained even if you remove your hands from it.
(3) Hold the media holder flange, turning it in the take-up direction to eliminate the slack in the me-
dia.
Setup of New Media
Basic Operations
37