Rockwell ArmorStratix 5700 series, Instructions Manual

Page: 335 / 548

Rockwell Automation Publication 1783-UM007F-EN-P - September 2016 335
Configure Switch Features Chapter 7
To change the default settings after adding an EIGRP instance, on the EIGRP
Instances tab, click the button in the row to customize, and then click
Customize Default Settings.
Static Neighbor —EIGRP hello packets are sent as multicast packets. If an EIGRP neighbor is located across a nonbroadcast network, such as a tunnel, you must manually define
that neighbor. When you manually define an EIGRP neighbor, hello packets are sent to that neighbor as unicast messages.
EIGRP ID Choose the Autonomous System (AS) number of the EIGRP routing process.
Neighbor Type the IP address of the neighbor.
Interface Choose the interface through which the neighbor is available.
Summary Address —Define summary addresses in either of these scenarios:
• If you want to create summary addresses that do not occur at a network number boundary
• If you want to use summary addresses on a router with automatic route summarization disabled.
If any more specific routes are in the routing table, EIGRP advertises the summary address out the interface with a metric equal to the minimum of all more specific routes.
EIGRP ID Choose the Autonomous System (AS) number of the EIGRP routing process.
Network Address Type the IP address of the summary address.
Net Mask Choose the network mask of the summary address.
Administrative Distance Type the distance value of the summary address.
Default: 5
Table 88 - EIGRP Fields (Continued)
Field Description
IMPORTANT Setting metrics is complex and is not recommended without guidance from
an experienced network designer.