Rockwell ArmorStratix 5700 series, Instructions Manual

Page: 121 / 548

Rockwell Automation Publication 1783-UM007F-EN-P - September 2016 121
Install Stratix 5410 Switches Chapter 4
SFP modules are inserted into SFP module slots on the front of the switch.
These field-replaceable modules provide the uplink optical interfaces, send
(TX) and receive (RX).
You can use any combination of compatible SFP modules:
• Each SFP module must be of the same type as the SFP module on the
other end of the cable. The cable must not exceed the stipulated cable
length for reliable communications.
• Once you install SFP modules in the switch, be aware that the overall
temperature rating of the combined modules (switch and SFP modules)
is limited to the lowest maximum temperature rating and the highest
minimum temperature rating.
For cable length and temperature specifications, see the Stratix Ethernet Device
Specifications Technical Data, publication
1783-TD001 .
To insert an SFP module into an SFP slot, follow these steps.
1. Attach an ESD-preventive wrist strap to your wrist and to a bare metal
surface.
2. Find the send (TX) and receive (RX) markings on the top of the
module.
On some SFP modules, the send and receive (TX and RX) markings are
replaced by arrows that show the direction of the connection.
3. If the module has a bale-clasp latch, move it to the open, unlocked
position.
4. Align the module in front of the slot opening and push until you feel the
connector snap into place.
5. If the module has a bale-clasp latch, close it.
32569-M
16
13
Disp.
Mode
EIP
Mod
EIP
Net
Setup
GPS
T
imeCD 3
1
4
2
Out
1
2
Speed
Duplex
PRP DLR PoE
Express
Setup
Alarms PSU
1 4
5
8 9
12
13
16 17
20 21
24 27 28
25 26
1
4