Rockwell Automation Allen-Bradley PowerFlex 700AFE, User Manual

Page: 86 / 186

86 Rockwell Automation Publication 20Y-UM001F-EN-P - April 2017
Chapter 3 Startup
4. Verify that the control power voltage is correct.
5. When DC disconnects are used for each inverter, verify that the
disconnect levers for all inverters are set to off.
6. Set the REM-MAN-AUTO switch to MAN.
7. Set the OFF-ON-START switch to OFF.
Programming the AFE
1. Turn the AFE circuit breaker handle to on.
2. Set parameter 091 [Reset To Defaults] to the appropriate setting for
your installation.
3. Use the HIM to enter the Assisted Start-up procedure.
Figure 41 - Active Front End Start-up Procedure Menu
091 [Reset to Defaults]
Resets parameters to default configurations except parameters 093 [Language] and
090 [Param Access Lvl].
0 (ready) = A new value can be entered.
1 (factory) = Resets parameters to default configurations.
2 (low voltage) = Resets parameters to default configurations and configures parameters
for a:
– 400/480V AFE unit for 400V operation.
– 600/690V AFE unit for 600V operation.
3 (high voltage) = Resets parameters to default configurations and configures parameters
for a:
– 400/480V AFE unit for 480V operation.
– 600/690V AFE unit for 690V operation.
IMPORTANT: The DC bus voltage must be present to set the voltage class.
Default:
Options: 0
0
1
2
3 Ready
Ready
Factory
Low voltage
High voltage
Step Example LCD Display
a. In the Main Menu, use the or
key to scroll to ‘Start Up’.
b. Press the (Enter) key.
F-> Stopped Auto
0.0
Volt
Main Menu:
Memory Storage
Start Up
Preferences
Input Voltage
Select
Startup
Alarm/Flt Cnfg Limits DC Bus Ctrl Start/Stop/I/O
Main Menu:
Sets Input
Voltage
Defines
Configurable
Alarms and Faults
Sets Current and
Power Limits
Sets the DC Bus
Voltage Reference
Configures
Digital Inputs
(including Run),
Digital Outputs, and
Analog Outputs