Rockwell Automation Allen-Bradley PowerFlex 700AFE, User Manual

Page: 85 / 186

Rockwell Automation Publication 20Y-UM001F-EN-P - April 2017 85
Chapter
3
Startup
This chapter describes how to start up the Active Front End. For a brief
description of the HIM, see Appendix B .
The basic start-up procedure must be performed when starting a new AFE to
verify the condition of the unit, and to configure essential parameters for
operating the AFE.
Names of the switches, push buttons, and status indicators are different for an
AFE in an IP20 2500 MCC Style enclosure and an AFE in an IP21 Rittal
enclosure. See the appropriate subsection for your enclosure.
AFE in IP20 2500 MCC Style
Enclosure
This procedure requires that a HIM is installed. If an operator interface is not
available, remote devices must be used to start up the AFE.
Startup Procedure
Before Applying Power to the AFE
1. Verify that the input circuit breaker is off.
2. Confirm that all wiring to the AFE (AC Input, ground, DC bus, and I/
O) is connected to the correct AFE terminals and is secure.
3. Verify that AC line power at the disconnect device is within the rated
value of the AFE.
Topic Page
AFE in IP20 2500 MCC Style Enclosure 85
AFE in IP21 Rittal Enclosure 90
ATTENTION: Power must be applied to the Active Front End to perform the
following start-up procedure. Some of the voltages present are at incoming
line potential. To avoid electric shock hazard or damage to equipment, only
qualified service personnel must perform the following procedure. Thoroughly
read and understand the procedure before beginning. If an event does not
occur while performing this procedure,
do not proceed . Remove power ,
including user-supplied control voltages. User-supplied voltages can exist
even when main AC power is not applied to the AFE. Correct the malfunction
before continuing.