RCT3:
Place the compression mode adjuster knob onto the compression
top cap with the long tab near the
front
of the crown. Turn the knob
clockwise
until it engages the first detent space.
RC:
Place the low speed compression adjuster knob onto the compression
top cap with the long tab near the
back
of the crown. Turn the knob
counter-clockwise
until it engages the first detent space.
RCT3:
Thread the knob retaining nut into the compression cam assembly.
While holding down the compression mode adjuster knob, tighten the knob
retaining nut. Turn the knob clockwise through both clicks until it stops, and
use a torque wrench with a 6 mm socket to tighten the knob retaining nut to
3.5-4.0 N•m (30-35 in-lb).
Make sure the knob retaining nut is not cross-threaded as it can move
the adjuster knob beneath it.
RC:
Install the knob retaining nut. While holding down the compression
knob, use a torque wrench with a 4 mm hex bit socket to tighten the nut to
4.0-5.5 N•m (40-50 in-lb).
4
RC
RC
RCT3
RCT3
5
6 mm
3.5-4.0 N•m (30-35 in-lb)
6
4 mm
4.0-5.5 N•m (40-50 in-lb)
40
Charger Damper™ Installation
