Use your fingers to install the bottom bolt into the rebound damper shaft,
then pull down on the bottom bolt.
Cover the top cap with a rag and cycle the rebound damper shaft a few
times to pre-bleed air from the damper.
Pull the rebound damper shaft down until it stops.
⚠
CAUTION - HAZARD
Cycle the rebound damper shaft very slowly. Failure to do so can result in
oil ejecting from the top cap. Wear safety glasses.
Fill the RockShox® Charger bleed syringe half full with 3wt suspension oil
and thread the syringe and Charger hose fitting into the compression top
cap assembly.
NOTICE
Only use the syringe included with the RockShox Charger Bleed kit.
Do not use a syringe that has been in contact with DOT
brake fluid. DOT brake fluid will permanently damage
the seals and cause the damper to malfunction.
3
4
5
3wt
RockShox Charger bleed syringe
35
Charger Damper™ Bleed
