Lightly clamp the cartridge tube into a bicycle stand with the rebound
damper shaft oriented upward.
NOTICE
Clamp the cartridge tube into the bicycle just tighten enough so that
it does not slip or spin. The tube can deform if clamped too tightly.
Place a 21 mm open end wrench on the wrench flats of the cartridge tube.
Place a 23 mm open end wrench on the damper seal head.
Holding the cartridge tube in place, turn the damper seal head counter-
clockwise to loosen and remove the rebound assembly.
Remove the cartridge tube from the bicycle stand and pour the suspension
oil into an oil pan.
Use your fingers to remove the glide ring from the rebound damper piston.
Use your fingers to install a new glide ring.
5
6
21 mm
23 mm
7
8
26
Charger Damper™ Removal
