Create a vacuum in the damper assembly by pulling up on the syringe
handle and simultaneously pushing up on the rebound damper shaft. This
will force bubbles out of the damper assembly.
Pressurize the damper assembly by pushing down on the syringe handle
and simultaneously pulling down on the rebound damper shaft.
Continue to hold down on the syringe handle and simultaneously cycle the
rebound damper shaft a few times to purge bubbles.
The bladder will expand and contract. This is normal.
Repeat pulling a vacuum and pressurizing the damper assembly until only
very small bubbles emerge from the damper assembly.
Make sure the rebound damper shaft is fully extended.
Push the syringe handle down and release it. Allow the bladder to come to
its natural resting position by waiting a few moments until the syringe stops
filling.
Use a rag to cover the bleed tip and Charger bleed port, then unthread and
remove the syringe.
⚠
CAUTION - EYE HAZARD
Oil may eject from the bladder assembly if the bladder is not in its resting
position. Wear safety glasses.
6
7
36
Charger Damper™ Bleed
