Slide the lower leg assembly along the upper tubes until it stops and the
spring and damper shafts are visible through the lower leg bolt holes.
Use a rag to clean all excess oil from the outer surface of the lower leg.
Install a new crush washer on the non-drive side and drive side bottom
bolts.
NOTICE
Dirty or damaged crush washers can cause leaks.
Thread the black bottom bolt into the non-drive side lower leg. Thread the
silver bottom bolt into the drive side shaft of the lower leg.
Use a torque wrench with a 5 mm hex bit socket to tighten the bolts to
7.3 N·m (65 in-lb).
Install the rebound adjuster knob onto the rebound damper bottom bolt.
Use a torque wrench with a 2.5 mm hex bit socket to tighten the set screw
to 1.1 N·m (10 in-lb).
NOTICE
Hold the rebound adjuster knob in place during installation to prevent
damage to the bottom bolt.
5
6
Spring side
Damper side
7
5 mm
7.3 N·m (65 in-lb)
5 mm
7.3 N·m (65 in-lb)
8
2.5 mm
1.1 N·m (10 in-lb)
43
Lower Leg Installation
