Wrap a rag around the cartridge tube.
Pour RockShox 3wt suspension oil into the cartridge tube until it is full.
Insert a 2.5 mm hex wrench into the rebound damper shaft until it contacts
the rebound adjuster screw. Turn the hex wrench counter-clockwise until it
stops. The rebound adjuster is now in the open position.
Wrap a rag around the cartridge tube.
Insert the rebound damper piston into the tube and thread the seal head
into the tube by hand.
Place a torque wrench with a 23 mm crowfoot open end wrench on the
wrench flats on the damper seal head. Place a 21 mm open wrench on the
wrench flats of the cartridge tube.
While holding the cartridge tube in place, turn the seal head clockwise to
tighten to 9-10 N•m (80-90 in-lb).
Install the crowfoot onto the torque wrench at a 90° angle to the handle
to ensure an accurate torque reading.
Remove the cartridge tube from the bicycle stand.
5
3wt
6
2.5 mm
7
8
21 mm
9-10 N•m (80-90 in-lb)
23 mm
32
Charger Damper™ Assembly
