Roche OMNI C, Instructions For Use Manual

Page: 32 / 152

1 Introduction
1-24
Instructions for Use, Roche OMNI C, Rev. 4.0, December 2002
• Make sure that the printer lever is in the "down" position (see Fig. 22).
Fig. 22
• Cut off, at a right angle, the start of the paper.
•
Feed in the start of the paper according to the sticker on the inside of the printer
cover.The paper is automatically pulled into the printer.
• Close the printer cover and feed the paper outward through the slit in the printer cover.
Fig. 23
15. Insertion of bottles
TIP: To avoid splashing the C1 and C2 calibration solutions, deaerate the bottles at about
3000 m above sea level or higher before inserting them.
• To do this, place the bottle tool on the screw cap of the C1 or C2 (Fig. 24/1).
• Press the grips together and press the transparent disk downward (Fig. 24/2).
• Rotate the transparent disk in the clockwise direction. Stop when you notice (after a
short distance) resistance (Fig. 24/3).
Fig. 24
printer lever
slit in the printer cover
(1) (2) (3)