Rigol DS2000E Series, User Manual, Page: 54 / 283

RIGOL Chapter 2 To Set the Vertical System
2-2 DS2000E User’s Guide
To Enable the Analog Channel
DS2000E provides 2 analog input channels (CH1 and CH2) and provides independent
vertical control system for each channel. As the setting methods for the vertical
systems of the two channels are the same, this chapter takes CH1 as an example to
illustrate the setting method for the vertical system.
Connect a signal to the input connector of CH1 and then press CH1 in the vertical
control area (VERTICAL) on the front panel to enable CH1.
At this point, the channel setting menu is displayed at the right side of the screen and
the channel status label at the bottom of the screen (as shown in the figure below) is
highlighted. The information displayed in the channel status label is related to the
current channel setting.
After the channel is turned on, modify the parameters such as the vertical scale,
horizontal time base and trigger mode according to the input signal to make the
waveform display easy to be observed and measured.