Ricoh TCRU/ORU, Troubleshooting Manual

Page: 73 / 184

(b) Adjust the print speed setting
1. Decrease the line speed. This will decrease the throughput, but is it OK?
Yes Go to the next step.
No Proceed to "(e) Decrease the heat roller temperature".
2. In [Advanced Settings] for the custom paper you are using, select 1231: [Print Speed],
and then decrease the value in the following corresponding settings by one level.
If the present value is [High], select [Middle]. If it is [Middle], select [Low].
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
• [BW/FC/FCS: Fuser Setting HQ]
[BW/FC/FCS]
• [FCS: Fuser Setting HQ]
[Clear/Special], [White]
• [S: Fuser Setting HQ]
[Clear/Special], [White]
3. Is the setting set to [Middle]?
Yes Proceed to "(c) If [Print Speed] is set to [Middle]".
No Proceed to "(d) If [Print Speed] is set to [Low]".
(c) If [Print Speed] is set to [Middle]
1. In [Advanced Settings] for the custom paper you are using, select 1232: [Fusing
Temperature], and then decrease the value in the following corresponding settings by
5°C.
• [BW/FC/FCS]
[Heat Roller Temp]
• [FCS]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S]
Uneven Density
71