Ricoh TCRU/ORU, Troubleshooting Manual

Page: 22 / 184

• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
Carry out the following sequence of procedures. Terminate the sequence as soon as the problem is
resolved.
Procedure 1: Changing the fusing temperature
1. In [Advanced Settings] for the custom paper you are using, select 1232: [Fusing
Temperature], and then adjust the value in the following corresponding settings by
5°C.
• [BW/FC/FCS]
[Heat Roller Temp]
• [FCS]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [BW/FC/FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
2. Print the image and check toner fusion. Has the problem been resolved?
Yes Finished!
No Increase the temperature an additional 5°C.
3. Repeat Step 2.
If the problem persists even if you increase the temperature to 190°C, perform Procedure
2,"Image processing 1".
Procedure 2: Changing the print speed
This will slow down the printing to give the toner more time to fuse. However, because of this,
throughput will be reduced.
3. Specifying and Checking Paper Settings
20