Ricoh M160, Service Manual

Page: 720 / 836

Bit Switches - 2
SM 64 M160/M161 Fax Option
4.4 BIT SWITCHES - 2

Do not adjust a bit switch or use a setting that is described as "Not used", as this may
cause the machine to malfunction or to operate in a manner that is not accepted by local
regulations. Such bits are for use only in other areas, such as Japan.
Default settings for bit switches are not listed in this manual. Refer to the System Parameter List
printed by the machine.
4.4.1 I-FAX SWITCHES
I-fax Switch 00 (SP No. 1-102-001)
No Function Comments
-
Original Width of TX Attachment
File
This setting sets the maximum size of the
original that the destination can receive. (Bits
3-6 are reserved for future use or not used.)
0 A4
1 B4
2 A3
3-6 Reserved
0: Off (not selected), 1: On (selected)
If more than one of these three bits is set to "1", the larger size has priority. For
example, if both Bit 2 and Bit 1 are set to "1" then the maximum size is "A3" (Bit
2).
When mail is sent, there is no negotiation with the receiving machine at the
destination, so the sending machine cannot make a selection for the receiving
capabilities (original width setting) of the receiving machine. The original width
selected with this switch is used as the RX machine's original width setting, and
the original is reduced to this size before sending. The default is A4.
If the width selected with this switch is higher than the receiving machine can
accept, the machine detects this and this causes an error.