Ricoh M160, Service Manual

Page: 683 / 836

Error Codes
M160/M161 Fax Option 27 SM
M
160/
M
161 F
A
X
OP
T
ION
Code Meaning Suggested Cause/Action
15-94 Incorrect ID Code The machine rejected an incoming e-mail for
transfer request, because the ID code in the
incoming e-mail did not match the ID code
registered in the machine.
15-95 Transfer Station Function The machine rejected an incoming e-mail for
transfer because the transfer function was
unavailable.
22-00 Original length exceeded the
maximum scan length

Divide the original into more than one
page.

Check the resolution used for scanning.
Lower the scan resolution if possible.

Add optional page memory.
22-01 Memory overflow while
receiving

Wait for the files in the queue to be sent.

Delete unnecessary files from memory.

Transfer the substitute reception files to an
another fax machine, if the machine’s
printer is busy or out of order.

Add an optional SAF memory card or hard
disk.
22-02 Tx or rx job stalled due to line
disconnection at the other end

The job started normally but did not finish
normally; data may or may not have been
received fully.

Restart the machine.
22-04 The machine cannot store
received data in the SAF

Update the ROM

Replace the FCU.
22-05 No G3 parameter confirmation
answer
Defective FCU board or firmware
23-00 Data read timeout during
construction

Restart the machine.

Replace the FCU.
25-00 The machine software resets
itself after a fatal transmission
error occurred

Update the ROM.

Replace the FCU.