Ricoh M160, Service Manual

Page: 673 / 836

Error Codes
M160/M161 Fax Option 17 SM
M
160/
M
161 F
A
X
OP
T
ION
Code Meaning Suggested Cause/Action
6-09 G3 ECM - ERR received

Check for a noisy line.

Adjust the tx levels of the communicating
machines.

See code 6-05.
6-10 G3 ECM - error frames still
received at the other end after
all communication attempts at
2400 bps

Check for line noise.

Adjust the tx level (use NCU parameter 01
or the dedicated tx parameter for that
address).

Check the line connection.

Defective remote terminal
6-21 V.21 flag detected during high
speed modem communication
The other terminal may be defective or
incompatible.
6-22 The machine resets the
sequence because of an
abnormal handshake in the
V.34 control channel

Check for line noise.

If the same error occurs frequently, replace
the FCU.

Defective remote terminal
6-99 V.21 signal not stopped within
6 s
Replace the FCU.
13-17 SIP user name registration
error

Double registration of the SIP user name

Capacity for user-name registration in the
SIP server is not sufficient.
13-18 SIP server access error

Incorrect initial setting for the SIP server

Defective SIP server
13-24 SIP authentication error

Registered password in the device does
not match the password in the SIP server.
13-25 Network I/F setting error

IPV4 is not active in the active protocol
setting.

IP address of the device is not registered.
13-26 Network I/F setting error at
power on

Active protocol setting does not match the
I/F setting for SIP server.

IP address of the device is not registered.
13-27 IP address setting error IP address of the device is not registered.