3.3.2. ISDN G4 Interface *
Note: If an optional Printer Interface Unit is installed, remove it before doing
the following procedure, and put it back afterwards.
Installation Procedure
1. Remove the rear cover [A] (4
screws), and the left cover [B] (3
screws and the connector cover).
Then, remove the small cover [C]
from the rear cover as shown in
Fig.1.
2. This step is necessary only for
the Europe model.
Attach the inner bracket [D] (3
screws) and the grounding plate
[E] (3 screws) as shown.
3. Attach the grounding wire [F], and
connect the ISDN board [G] to
the FCE through the interface har-
ness [H] as shown in Fig. 3.
Install the ISDN board into the
machine as shown in Fig.4 on the
next page.
4. Secure the ISDN board [G] to the
machine with 2 screws and the
support holder [ I ] (1 screw).
[A]
[C]
[B]
H143i501.wmf
[E]
[F]
[D]
H143i510.wmf
[G]
[H]
[ I ]
H143i511.WMF
INSTALLATION *
December 21st, 1995
INSTALLING OPTIONAL UNITS
3-4
