G3 Switch 0A
FUNCTION
COMMENTS
6
Reconstruction time for the
first line in receive mode
0: 6 s 1: 12 s
When the sending terminal is controlled by a computer,
there may be a delay in receiving page data after the
local machine accepts set-up data and sends CFR.
This is outside the T.30 recommendation. But, if this
delay occurs, set this bit to 1 to give the sending
machine more time to send data.
Refer to error code 0-20.
ITU-T T.30 recommendation: The first line should come
within 5 s of CFR.
7
Not used
Do not change the settings.
G3 Switch 0B
FUNCTION
COMMENTS
0
Protocol requirements:
Europe
0: Disabled 1: Enabled
The machine does not automatically reset these bits
for each country after a country code (System Switch
0F) is programmed.
Change the required bits manually at installation.
1
Protocol requirements:
Spain
0: Disabled 1: Enabled
2
Protocol requirements:
Germany
0: Disabled 1: Enabled
3
Protocol requirements:
France
0: Disabled 1: Enabled
4
PTT requirements: Germany
0: Disabled 1: Enabled
5
PTT requirements: France
0: Disabled 1: Enabled
6
Not used
Do not change the settings.
7
G3 Switch 0C
FUNCTION
COMMENTS
0
1
Pulse dialing method
Bit 1 Bit 0 Setting
0 0 Normal (P=N)
0 1 Oslo (P=10 - N)
1 0 Sweden (N+1)
1 1 Not used
P = Number of pulses sent out, N = Number dialed.
2
to
7
Not used
Do not change the settings.
SERVICE TABLES AND PROCEDURES
December 21st, 1995
BIT SWITCHES
4-54
