4.2.3. Printer Switches
Printer Switch 00
No
FUNCTION
COMMENTS
0
Page separation mark
0: Disabled
1: Enabled
0: No marks are printed.
1: If a received page has to be printed out on two
sheets, an "x" inside a small box is printed at the
bottom right hand corner of the first sheet, and a "2"
inside a small box is printed at the top right hand
corner of the second sheet. This helps the user to
identify pages that have been split up.
1
Repetition of data when the
received page is longer than
the printer paper
0: Disabled 1: Enabled
0: The next page continues from where the previous
page left off.
1: The final few mm of the previous page are printed at
the top of the next page.
See section 2.2.12 for details.
2
Not used
Do not change the settings.
3
Cleaning mode after bypass
feed
0: Disabled
1: After each page is fed
from the bypass feed slot
0: Cleaning mode is not done at all if bypass feed is
used.
1: Cleaning mode is done every time after a sheet of
paper is fed from the bypass feed slot.
4
to
6
Not used
Do not change the settings.
7
mm-inch conversion when
printing
0: Disabled 1: Enabled
0: Printing is always done in inch format.
1: If the other end has scanned the document in mm
format, the machine converts the data to inch format
before printing.
Refer to section 2.2.13 for details.
Printer Switch 01 - Not used (do not change the settings)
Printer Switch 02 - Not used (do not change the settings)
Printer Switch 03
No
FUNCTION
COMMENTS
0
Length reduction of
received data
0: Disabled
1: Enabled
0: Incoming pages are printed without length
reduction.
Cross reference
Page separation threshold: Printer Sw. 03, bits 4 to 7.
1: Incoming pages are reduced in the length direction
when printing.
Cross reference
Reduction ratio: Printer Switches 04/05
Page separation and data reduction: section 2-2-12
1
Not used
Do not change the settings.
2
3
SERVICE TABLES AND PROCEDURES
December 21st, 1995
BIT SWITCHES
4-38
