Communication Switch 14
No
FUNCTION
COMMENTS
0
Inch-to-mm conversion
during transmission
0: Disabled 1: Enabled
0: Transmitting is always done in inch format.
1: If the other end only has mm-based resolution for
printing, the machine converts the scanned data to
mm-format before transmission.
Refer to section 2.1.8 for details.
1
to
5
Not used
Do not change the factory settings.
6
7
Available unit of resolution
in which fax messages are
received
Bit 7 Bit 6 Unit
0 0 mm
0 1 inch
1 0 mm and inch
(default)
1 1 Not used
For the best performance, do not change the factory
settings.
The setting determined by these bits is informed to the
transmitting terminal in the pre-message protocol
exchange (in the DIS/NSF frames).
Communication Switch 15
No
FUNCTION
COMMENTS
0
to
7
Available resolution for
receiving fax messages
Bit 0 1: 200 x 100/8 x 3.85
Bit 1 1: 200 x 200/8 x 7.7
Other bits: Not used
For the best performance, do not change the factory
settings.
The setting determined by these bits is informed to the
transmitting terminal in the pre-message protocol
exchange (in the DIS/NSF frames).
Communication Switch 16 - Not used (do not change the settings)
Communication Switch 17 - Not used (do not change the settings)
Communication Switch 18 - Not used (do not change the settings)
Communication Switch 19 - Not used (do not change the settings)
Communication Switch 1A - Not used (do not change the settings)
Communication Switch 1B - Not used (do not change the settings)
Communication Switch 1C - Not used (do not change the settings)
Communication Switch 1D - Not used (do not change the settings)
Communication Switch 1E - Not used (do not change the settings)
Communication Switch 1F - Not used (do not change the settings)
SERVICE TABLES AND PROCEDURES
December 21st, 1995
BIT SWITCHES
4-48
