System Switch 0A
No
FUNCTION
COMMENTS
0
1
Default communication
mode
Bit 1 Bit 0 Setting
0 0 G3
0 1 Not used
1 0 G4
1 1 Not used
These bits determine the machine’s standby default
communication mode if a G4 option has been installed.
2
Not used
Do not change the settings.
3
Continuous polling reception
0: Disabled 1: Enabled
This feature allows a series of stations to be polled in a
continuous cycle.
4
Dialing on the ten-key pad
when the external
telephone is off-hook
0: Disabled 1: Enabled
0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting when
the external telephone is not by the machine or a
wireless telephone is connected as an external
telephone.
1: The user can dial on the machine’s ten-key pad
when the handset is off-hook.
5
On hook dial
0: Disabled 1: Enabled
0: On hook dial is disabled.
6
Line used for G3
transmission
0: PSTN 1: ISDN
If an ISDN kit has been installed, this bit determines
whether G3 transmissions go out over the PSTN or the
ISDN.
7
Line used when the
machine falls back to G3
from G4 if the other end is
not a G4 machine
0: PSTN 1: ISDN
This bit switch has no effect if Communication Switch
07 bit 0 is set to 0.
System Switch 0B
No
FUNCTION
COMMENTS
0
1
Automatic reset timer
Bit 1 Bit 0 Timer setting
0 0 1 minute
0 1 3 minutes
1 0 5 minutes
1 1 No limit
(1, 1): Automatic reset is disabled.
(Other): The machine returns to the standby mode
when the timer expires after the last operation.
2
3
Energy Saver mode timer
Bit 3 Bit 2 Time Limit
0 0 1 minute
0 1 3 minutes
1 0 5 minutes
1 1 No limit
(1, 1): Automatic Energy Saver mode is disabled.
(Other): The machine goes into an Energy Saver
mode when the timer expires after the last operation.
Cross reference
Energy Saver modes: Section 2.3.1
4
to
7
Not used
Do not change the settings.
SERVICE TABLES AND PROCEDURES
December 21st, 1995
BIT SWITCHES
4-32