Ricoh AP-P2 G188, Field Service Manual

Page: 409 / 682

040
1bin: Paper Feed: Pressure
Temp
*ENG [20 to 120 / 90 / 1 deg/step]
Specifies the threshold of the pressure roller for the paper feed to the 1bin tray in 600 dpi
mode.
041
F :1bin: Paper Feed: Pressure
Temp
*ENG [20 to 120 / 80 / 1 deg/step]
Specifies the threshold of the pressure roller for the paper feed to the 1bin tray in 1200 dpi
mode.
1105 [Fusing Temperature] Fusing Temperature Adjustment
(Printing Mode, Roller Type, [Color], Simplex/Duplex)
Roller Type –> Center and Ends: Heating roller, Pressure –> Pressure roller
Paper Type -> Plain, Thin, Thick, OHP, Middle Thick, Special
001
Fusing Ready Temp. *ENG
[150 to 200 / P2c: 165, P2d: 170 / 1 deg/
step]
Specifies the heating roller target temperature for the ready condition.
002
Fusing Ready: Offset *ENG [0 to 100 / 5 / 1 deg/step]
Sets the heating roller offset temperature for the printing ready condition.
Ready temperature = (Target temperature specified in SP1-105-1) – Temperature specified
in this SP mode
007
Fusing Ready Temp: H *ENG
[150 to 200 / P2c: 165, P2d: 170 / 1 deg/
step]
Sets the heating roller offset temperature at the end of the heating roller. This value is one of
the thresholds to determine if the machine is at the heating roller target temperature during
warm-up.
008
Ready Target Add Pressure *ENG [0 to 200 / 80 / 1 deg /step]
Sets the upper limit temperature of the heating roller at the end of the heating roller. This
value is one of the thresholds to determine if the machine is at the heating roller target
temperature during warm-up.
012
Panel Off1: Pressure * ENG [60 to 130 / 90 / 1 deg/step]
Sets the pressure roller offset temperature. This value is one of the thresholds to determine if
the machine is at the heating roller target temperature during warm-up.
Engine Service Mode
151
8