Ricoh Aficio 6010, Operating Instructions Manual

Page: 221 / 282

205
Others
Use and Storage of Suplies
Use and Storage of Supplies
Copy Paper
❐
Copy paper of the types or in the conditions listed below are not recommended for this copier.
•
Folded, curled, creased, or damaged paper
•
Torn paper
•
Perforated paper
•
Paper with conductive or low electrical resistance coating such as carbon or silver coating
•
Thermal paper, art paper
•
Thin paper that has low stiffness
•
Damp paper
•
Wavy paper
•
Stapled paper
❐
Never use ink-jet printer paper to prevent failure.
❐
Use a proper type OHP transparency and set it in correct direction to prevent failure.
❐
Fan copy paper and OHP transparencies to get air between the sheets before loading.
❐
Do not touch copy paper if your fingers are wet or oily; finger prints may appear on the copy.
❐
Load paper with the copy side down in the paper trays. If copies are curled, try turning the copy paper over in the tray.
If there is no improvement, change to copy paper with less curl.
❐
When copying on rough surface paper, the copy image may be light.
❐
When setting paper thinner than 64g/m 2 , 17 lb or translucent paper in the paper trays or bypass trays, set it as shown
in the figure below. The paper is divided into the vertical and horizontal types depending on the texture flow direction.
If you set thin paper or translucent paper in the reverse direction, a paper jam might occur. Since A3, B4, 11"
×
17", and
8
1/2
"
×
14" sizes of thin paper are set in the lengthwise direction in this machine, they must be of the vertical type.
Texture flow Setting paper Setting paper
in the paper trays in the bypass tray
Vertical
type
Horizontal
type
GCYOSI1E
GCYOSI2E