Rice Lake REVOLUTION 682 Synergy Plus, Technical Manual

Page: 43 / 130

Configuration
© Rice Lake Weighing Systems ● All Rights Reserved 35
4.5.3 Calibration Menu
This section provides a flow chart and descriptions for the Calibration menu.
Figure 4-9. Calibration Menu
Table 4-8. Calibration Menu Parameter
Parameter Description
Zero Calibration
Executes the zero calibration process ( Section 6.1 on page 56 )
Zero Counts
Displays the raw count value at the zero weight; A zero calibration generates this raw count value; Manually changing this count value
changes the zero weight and negates the zero calibration
Test Weight
Sets the test weight value for the span calibration ( Section 6.1 on page 56 ); Enter value: 0.000001–9999999.999999, 10000.0 (default)
Span Calibration Executes the span calibration process (
Section 6.1.1 on page 56 )
Span Counts
Displays the raw count value at the span weight; A span calibration generates this raw count value; Manually changing this count value
changes the span weight and negates the span calibration
Linear Calibration Linear or multi-point calibration is performed by entering up to four additional calibration points (
Section 6.1.2 on page 57 );
Points 1-4 have the following sub-parameters:
Linear Point # Weight – Sets the test weight value for the linear calibration point
Calibrate Linear Point # – Executes the linear calibration process for the point; generates the raw count value for the test weight
value for Point #
Linear Point # Counts – Displays the raw count value at the linear point weight; A linear calibration generates this raw count
value; Manually changing this count value changes the linear point weight and negates the linear calibration for the point
Rezero
Removes an offset value from the zero and span calibrations ( Section 6.2.3 on page 57 )
Last Zero
Takes last push button zero in the system (from Weigh mode) and uses it as the new zero reference point, after which a new span
calibration must be performed; this calibration cannot be performed when calibrating a scale for the first time ( Section 6.2.1 on page 57 )
Temp Zero
Temporarily zeros the displayed weight of a non-empty scale, after a span calibration was performed;
The difference between the temporary zero and the previously calibrated zero value is used as an offset ( Section 6.2.2 on page 57 )
Point 3 Point 4 Point 2 Point 1
Linear Calibration Rezero Temp Zero
Point 4
Last Zero
Zero Calibration Zero Counts Span Calibration Test Weight Span Counts Temp Zero
Setup Tare User
Calibration Scale Format Communications