682 Synergy Plus
56
Visit our website
6.0
Calibration
The 682 can be calibrated using the front panel and EDP commands. The following sections describe the procedures required
for these calibration methods.
NOTE: The 682 requires a Zero Calibration and Span Calibration to be calibrated. The Linear Calibration points are optional;
they must fall between zero and span, but must not duplicate zero or span.
Figure 6-1. Setup – Calibration Menu
6.1 Front Panel Calibration
6.1.1 Span Calibration
Use the following procedure to perform a standard span calibration on a connected scale. Access to
Setup
mode (
) is required.
1. Navigate to the Configuration menu within the Setup menu.
Configuration
displays.
2. Press
twice.
Calibration
displays.
3. Press
.
Zero Calibration
displays.
NOTE: See
if the application requires a rezero, last zero or temporary zero.
4. Ensure there is no weight on the scale.
5. Press
to perform a zero calibration.
Please Wait
displays briefly and then
Zero Calibration
Complete
displays.
6. Press
.
Zero Counts
for more information on zero counts.
7. Press
.
Test Weight
displays.
8. Press
. The current test weight value displays.
9. Use the numeric keypad to enter a new value, if necessary.
10. Press
to accept value.
Span Calibration
displays.
11. Place the specified amount of test weight on the scale.
12. Press
to perform a span calibration.
Please Wait
displays briefly and then
Span Calibration
Complete
displays.
13. Press
.
Span Counts
for more information on span counts.
NOTE: Span calibration is complete. To continue with a linear calibration, see
before returning to
Weigh mode.
14. Press
to return to
Weigh
mode.
Point 3
Point 4
Point 2
Point 1
Linear Calibration
Rezero
Temp Zero
Point 4
Last Zero
Zero Calibration
Zero Counts
Span Calibration
Test Weight
Span Counts
Temp Zero
Setup
Tare
User
Calibration
Scale Format
Communications
Summary of Contents for REVOLUTION 682 Synergy Plus
Page 129: ......
