Operation
© Rice Lake Weighing Systems
●
All Rights Reserved
21
3.4 General Indicator Operation
This section provides procedures for basic 682 operations.
3.4.1 Zero Scale
1. In
Gross
mode, remove all weight from the scale and wait for
to display.
2. Press
,
displays to indicate the scale is zeroed.
NOTE: The scale must be stable and within the configured zero range for the scale to be zeroed.
3.4.2 Print Ticket
1. Wait for
to display.
2. Press
to send data to the configured port(s). The default print destination is RS-232 Port 1.
If
does not display and
is pressed, the print action only occurs if the scale comes out of motion within three
seconds. If the scale stays in motion for over three seconds, the
press is ignored.
3.4.3 Toggle Units
Press
to toggle between primary, secondary and tertiary units, if configured. The current unit displays.
3.4.4 Toggle Gross/Net Mode
NET
mode is available when a tare value has been entered or acquired (Net = Gross minus Tare). If tare has not been entered
or acquired, the display remains in
GROSS
mode. GROSS or NET is indicated on the left side of the display to indicate the
current mode. If a tare has been applied, the current tare weight displays in the lower middle of the weight display area.
Press
to toggle the display mode between
GROSS
mode and
NET
mode.
3.4.5 Acquire Tare
1. Place a container on the scale and wait for
to display.
2. Press
to acquire the tare weight of the container. The net weight displays and the Net is indicated on the left
side of the display. A “
T
” displays in the lower middle of the weight display area, followed by the current Tare weight.
3.4.6 Remove Stored Tare Value
1. Remove all weight from the scale and wait for
to display. The display reads the negative tare value
and
displays.
NOTE: Press
to zero the scale, if
is not displayed.
2. Press
(or
in
OIML
mode). Display changes to gross weight and Gross is indicated on the display.
Summary of Contents for REVOLUTION 682 Synergy Plus
Page 129: ......
