682 Synergy Plus
94
Visit our website
12.18 Digital I/O Commands
The following commands can be used to configure digital I/O parameters.
12.19 Analog Output Commands
The following commands can be used to configure analog output parameters.
12.20 Softkey Setting Commands
The following command can be used to configure the function of the five softkeys.
Table 12-18. Digital I/O Commands
Command
Description
Values
DIO
.b
#
s
Sets DIO type
OFF
(default), OUTPUT, PRIM, PRINT, SEC, TARE, UNITS, ZERO, BATRUN,
BATSTART, BATPAUSE, BATRESET, BATSTOP, CLEAR, CLRACC, CLRCN,
CLRTAR, DSPACC, DSPTAR, GROSS, KBDLOC, NET, NT/GRS
Valid bit values (
b
) are 1-4; For commands ending with
#s
, s is the slot assigned to the digital I/O (0); Slot 0 is onboard
Table 12-19. Analog Output Commands
Command
Description
Values
ALG.SOURCE#
s
Analog output source
SCALE1
(default), REMOTE
ALG.MODE#
s
Mode
GROSS
(default), NET
ALG.OUTPUT#s
Type of output
0-10V
(default), 0-20MA, 4-20MA
ALG.ERRACT#
s
Error action
FULLSC
(default), HOLD, ZEROSC
ALG.MIN#
s
Minimum value tracked
±9999999.0,
0.0
(default)
ALG.MAX#
s
Maximum value tracked
±9999999.0,
10000.0
(default)
ALG.TWZERO
Adjusts the offset of the analog output zero value
0–65535,
0
(default)
ALG.TWSPAN
Adjusts the offset of the analog output span value
0–65535,
59515
(default)
For commands ending with
#s
, s is the slot number assigned to the analog output (1)
Table 12-20. Softkey Commands
Command
Description
Values
SOFTKEY.FUNCTION
#s
Function assigned to each available softkey
NONE
(default), BLANK, TIMEDATE, DSPTAR, DSPACC,
SETPOINT, BATSTOP, BATSTRT
,
BATPAUS, BATRESET, STOP,
GO, OFF, DSPUID, TRUCKWEIGHIN, TRUCKWEIGHOUT,
ENTERTRUCKREGS, PRINTAUXFMT1, PRINTAUXFMT2,
PRINTAUXFMT3, PRINTAUXFMT4
For commands ending with
#s
, s is the softkey number (1-15)
Summary of Contents for REVOLUTION 682 Synergy Plus
Page 129: ......
