Load Ranger Wheel Weigh Pad System
40
Visit our website
www.RiceLake.com
5.2 Calibrate with Ai-1 Indicator
5.2.1 Standard Calibration
1. Navigate to the
Technical Setup
menu (
Section 4.2 on page 34
).
2. Press
.
3. Press
.
NOTE: To change calibration parameters (decimals, units, divisions, etc.), press
.
By changing parameters in one wheel weigh pad, the Ai-1 indicator sets all other paired wheel weigh pads to the same
parameters selected.
4. Press
. Calibration points message displays.
5. Press
. Calibration zero acquisition prompt displays.
6. Unload the wheel weigh pad and press
. Calibration acquisition of point 1 message displays.
7. Press
. Calibration point 1 weight prompt displays.
8. Enter the weight value of the calibration point and press
. Calibration load weight prompt displays.
9. Load the wheel weigh pad with a test weight equal to the entered value and press
. Once procedure is
complete, a successful calibration message displays.
10. Press
.
11. Press
to return to the
Calibration
menu.
12. Repeat
Step 3 on page 40
–
Step 11
until all wheel weigh pads have been calibrated.
13. Press
, then press
to save changes. Indicator restarts and returns to the weigh screen.
NOTE: When the Ai-1 indicator is off the wheel weigh pads do not retain the calibration settings configured through the Ai-
1 indicator. The wheel weigh pads return to their own previously configured settings or defaults. Once the Ai-1 indicator is
turned back on the indicator settings are restored from the previous use.
5.2.2 Zero Calibration
1. Navigate to the
Technical Setup
menu (
Section 4.2 on page 34
).
2. Press
.
3. Press
.
4. Press
. A prompt displays to unload the platform.
5. Unload the wheel weigh pad and press
. A prompt displays to confirm the zero calibration was successful
once procedure is complete.
6. Press
.
7. Press
to return to the
Calibration
menu.
8. Repeat
Step 3
–
Step 7
to complete a zero calibration for the remaining wheel weigh pads.
9. Press
, then press
to save changes. Indicator restarts and returns to the weigh screen.
Calibration
F1
F2
Scale 1
Scale X
FX
Parameters
F1
Calibration
F2
OK
OK
OK
OK
OK
OK
Esc
Yes
Calibration
F1
F2
Scale 1
Scale X
FX
Zero Calibration
F3
OK
OK
Esc
Yes
