W E B C O N T R O L P A N E L O P E R A T I O N
EDID
350-10035-01 v4.1.1
Linx DVI Matrix Switchers User’s Guide
39
The
EDID
window is used to manage the entries in the EDID list. EDID information is captured
from connected outputs and may be saved to the list.
There is a factory default EDID based on a preferred timing of 1920 x1200. Once a new user-
captured EDID is invoked, the default choice will disappear from the drop-down list. If this EDID is
needed, just perform an EDID capture from a non-connected output and save to the list. If not
named otherwise, it will display as
[email protected] RGB 0026
.
To save EDID data from a connected output, use the following procedure.
1. Click the EDID icon on the WCP. The window shown in
Figure 4-13
opens.
Figure 4-13 EDID Management Window
2. Select an output number from its drop-down list.
3. Select an entry number from the drop-down list.
4. Click
Save
. A window opens to name the EDID table entry.
Figure 4-14 Name EDID
5. Enter a name for the EDID table entry as required and click
OK
. If a name is not entered, the
preferred resolution and frame rate of the display’s EDID will be shown.
The EDID Management window can also be used to delete or rename a table entry.
4.6 EDID
Note
HDMI audio requires a 2-block EDID. The RGB Spectrum default EDID is single-
block and does not support audio.
