P H Y S I C A L D E S C R I P T I O N A N D I N S T A L L A T I O N
Linx 800S
350-10035-01 v4.1.1
Linx DVI Matrix Switchers User’s Guide
16
E T H E R N E T P O R T
The Ethernet port supports 100/1000 BASE-T on an RJ-45 connector.
R S - 2 3 2 P O R T
Serial control of the
Linx DVI Switcher
is supported through the RS-232 port on a DB-9
connector.
A C P O W E R
The AC power cord is connected to the power supply module. The power switch is to the
right of the supply. Note that cord (NEMA5-15P/IEC-C19, 15A, 6FT) uses an inlet plug
that is larger than typical. See
Chapter 9
for instructions on replacing the power supply.
The
Linx 800S
is contained in a 2-RU housing with standard rack-mounting brackets and rear rack
supports.
2.4.1
Supplied Components
Accessories supplied with the
Linx DVI Switcher
include one power cord and a CD that
contains this manual.
2.4.2
Front Panel Features
Features on the front panel include a power switch, LED indicators, a two-line display, and a
control knob.
CAUTION
It is not necessary to have all output slots populated with modules. But if a slot has
no module, a blank plate must be installed.
The AC power must be off before removing or installing an output module.
Note
Power supply fans run when AC power is connected even if the switch is set to off.
2.4 Linx 800S
