Respironics Trilogy 02, Technical Information

Page: 317 / 424

P
AGE
10-14
T
RILOGY
S
ERVICE
& T
ECHNICAL
I
NFORMATION
1002735, V
ER
. 05
Turn Device Power On
Press the Start/Stop button on the front of the ventilator. The system will begin operating using the defined
ventilation settings.
V
ERIFY THE
H
IGH
T
IDAL
V
OLUME
A
LARM
This procedure verifies that the High Tidal Volume alarm is working properly. For Passive and Active Flow
circuits, this will verify the High Vte alarm. For Active PAP circuits, this will verify the High Vti alarm. It assumes
that you have attached the test lung, verified the ventilator settings, and turned on ventilator power as
described in the Initial Setup section.
Change Alarm Ventilator Setting
Modify the High Tidal Volume alarm setting to match the one shown below.
Verify the Alarm
Wait up to 40 seconds and verify the following alarm signals:
•
The High Priority audible indicator sounds
•
A red light flashes on the Alarm Indicator/Audio Pause button
•
The High Tidal Volume alarm condition appears on the screen, highlighted in red
Modify Ventilator Alarm Settings
Modify the High Tidal Volume alarm setting to match the one shown below.
Verify Reset
Wait 40 seconds and verify the following auto-reset conditions:
•
The High Priority audible indicator has stopped sounding
•
The red light on the Alarm Indicator/Audio Pause button has stopped flashing
NOTE
Do not use the “reset” button to manually reset the alarm. Instead, use the “Modify”
button to change ventilator settings. This note applies to all tests.
SETTING VALUE
High Vte/High Vti 50 ml
SETTING VALUE
High Vte/High Vti 500 ml