Regency Fireplace Products Greenfire GF950L Series, Owners & Installation Manual

Page: 40 / 104

40
Regency GF950L-2 Gas Fireplace
HORIZONTAL TERMINATIONS - INLINE POWER FLUE
102MM X 168MM FLEX FLUE
These flueing systems, in combination with the GF950L-2 Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system. The location
of the termination cap must conform to the requirements in the Flue Terminal Locations diagram in "Exterior Flue Termination Locations" section.
Regency
®
Direct Vent (Flex) System Termination Kits include all the parts needed to install the GF950L-2 using a flexible flue.
Vent Guard - if required
(Part #946-506/P)
(TM) AstroCap
Termination Cap
(Part #946-523/P)
Wall Thimble
Adaptor Pipe
(Part # 946-219/P)
Maximum 2 - 6.10m
long liners
168mm
Dia. Flue Pipe
102mm
Dia. Flue Pipe
Power Flue Terminal
(Part # 946-765)
Notes:
1. Only Flex pipe purchased from Regency
®
may be
used for Flex installations
2. Horizontal flue must be supported every 0.9 meter.
3. Regency
®
Direct Vent System (Flex) is only approved
for horizontal terminations.
4. Flex system can only be used up to a maximum
flue length of up to 12m using up to 2 x 6m flex kits
(Part # 946-756). If longer runs are required, rigid
pipe must be used.
5. Must use adaptor pipe (946-219/P) to connect inner
flex pipe as shown.
IMPORTANT:The inline power flue must be installed
within the confines of the home/structure and must
be accessible for future servicing. An access hole
as noted in this manual or an attic space would be
suitable.
Maximum total flue length = 18m maximum of six-90 0
elbows permitted.
One 90
0 elbow = two 45 0 elbows
Maximum total negative flue length = 2,1m
Note: Maximum length of 18m is based on overall
length of combined chimney components.
Do not run positive flueing after a negative run.
Inline power flue location restrictions:
Minimum 1.2 m from the unit
Minimum 0.3 m prior to an elbow.
Minimum 0.3 m following an elbow.
Minimum 0.3 m prior to a termination cap.
Minimum 1.8 m rise from top of unit if there
is a negative run.
Power Flue Kit (Part 946-765)
2 Max. 946-756 6m Flex Kit Sold separately
1 Power Flue Fan Included w/Power Flue Kit
1 946-765 Power Flue Kit Sold separately
1 946-219/P Adaptor Pipe Included w/Power Flue Kit
1 946-206 Vinyl Siding Standoff Sold separately
1 946-523/P Astro Cap Termination Sold separately
1 946-763 Wall Thimble Sold separately
1 946-506/P Flue Guard Sold separately
1 911-339 PV Wiring Harness Included w/Power Flue Kit
installation