RED LOGIKA 25-35 REFILL, Installation Manual

Page: 86 / 124

4
3 - GENERAL WARNINGS
GENERAL PRECAUTIONS
The electrical safety of the system is guaranteed only when this is connected correctly to an efficient earthing system installed in
accordance with the safety standards in force: the pipes of the gas, water and heating systems do not constitute a suitable earth system.
It is necessary to ensure this essential safety requirement; if in doubt, have a qualified technician test the electrical system with care
because the manufacturer of the boiler does not assume responsibility for damage caused by the absence of an earthing system.
A qualified technician should check that the electrical system is compatible with the max consumption of the system, checking in
particular that the cross-section of the cables of the system is compatible with the power consumption of the loads.
The use of any component that requires electrical energy requires compliance with certain essential rules like:
• do not touch the appliance with wet and/or damp parts of the body and/or when barefoot;
• do not pull on the electrical cables;
• do not expose the appliance to the elements (rain, sun, etc.);
• do not allow children or inexperienced persons to use the appliance.
Connection to 230V power supply.
The installation of additional electrical components of the boiler requires electrical connection to a
230V - 50Hz
power supply: This
connection must be done in accordance with the national standards in force.
Danger!
Electrical installation must be entrusted to a single qualified technician.
Before making the connections or carrying out any work on the electrical parts, always turn off the power supply
and make sure it cannot be turned on again accidentally.
The power cable must be replaced only by an authorised technician. Failure to observe the above could compromise the safety of the
appliance.
ELECTRICAL CONNECTION
Connect the power cable first to the back of the tank and then to the electrical mains.
The main switch at the back is simply for turning on the boiler.
It is recommended to disconnect the power cable when the boiler is not used.
ELECTRICAL CONNECTION