re:3D Gigabot, Installation Manual

Page: 34 / 115

I13
I14
I15
Add the white plastic
limit switch mount. Note
that the holes are offset
slightly, and that the
narrower side should be
flush against the edge of
the side plate.
Add the limit switch, with
the hinge of the switch
pointing towards the front
of the Gigabot.
Place the M2 split washer and
M2 hex nut on the M2x16. You
can use your fingers to get
them started and just finger
tighten them before using the
1.5mm Allen Key and needle
nose pliers to fully tighten
them. You do not want the
force of the bed frame to be
able to move the limit switch
on its mount.
gigabot
®
: unassembled
174