re:3D Gigabot, Installation Manual

Page: 32 / 115

I7
I8
I9
Loop the belt into the
motor block as shown.
Recall the orientation of
the motor as mentioned
above.
See video for a
demonstration.
Mount the Y motor to the
frame using 2 M5x45 BHCS
and 2 M5 flat washers each.
If the belt is twisted, carefully
remove and replace it in
the proper orientation and
then mount the Y motor. Be
careful not to overtighten
these in case you strip the
threads in the plastic motor
blocks.
Do this for both Y motors.
Note that the left side Y
motor already has a limit
switch installed, while the
right side Y motor does
not use a limit switch.
gigabot
®
: unassembled
172